Date:2011-05-27 02:14:05 (8 years 6 months ago)
Author:Werner Almesberger
Commit:b830302e678a07eb20eabccf7d5dd431695e8791
Message:prod/doc/: added marked-up layout to indicate CLKM/CLK test points

- atben.fig, atusb.fig: layout images overlaid by markup
- Makefile: added images derived from atben.fig and atusb.fig
- Makefile: added generation of the layout images atben.fig and
atusb.fig are based on
- analysis.html: show measurement locations for CLKM and CLK
Files: prod/doc/Makefile (3 diffs)
prod/doc/analysis.html (3 diffs)
prod/doc/atben.fig (1 diff)
prod/doc/atusb.fig (1 diff)

Change Details

prod/doc/Makefile
1PNGS=flow.png setup-A.png setup-B.png setup-C.png setup-D.png
1PNGS=flow.png setup-A.png setup-B.png setup-C.png setup-D.png \
2     atben-A.png atusb-A.png \
3     atben-A-small.png atusb-A-small.png
24HTMLS=index.html setup.html flash.html test.html analysis.html
35JPGS=atusb-programming.jpg atrf-path.png atrf-path-small.png
46
...... 
1719            fig2dev -L png -m 0.7 -S 4 >$@ || \
1820            { rm -f $@; exit 1; }
1921
22atben-%-small.png: \
23          atben.fig
24        ./figfilt `echo $@ | tr -cd 'A-Z'` $< | \
25            fig2dev -L png -m 0.5 -S 4 >$@ || \
26            { rm -f $@; exit 1; }
27
28atben-%.png: atben.fig
29        ./figfilt `echo $@ | tr -cd 'A-Z'` $< | \
30            fig2dev -L png -m 2 -S 4 >$@ || \
31            { rm -f $@; exit 1; }
32
33atusb-%-small.png: \
34          atusb.fig
35        ./figfilt `echo $@ | tr -cd 'A-Z'` $< | \
36            fig2dev -L png -m 0.5 -S 4 >$@ || \
37            { rm -f $@; exit 1; }
38
39atusb-%.png: atusb.fig
40        ./figfilt `echo $@ | tr -cd 'A-Z'` $< | \
41            fig2dev -L png -m 2 -S 4 >$@ || \
42            { rm -f $@; exit 1; }
43
2044atusb-programming.jpg:
2145        wget $(DL)/atusb-programming.jpg
2246
...... 
2751          atrf-path.png
2852        convert -scale 50% $< $@
2953
54%-front.png:
55        $(MAKE) -C ../../$* $@
56        mv ../../$*/$@ .
57
3058upload: $(HTMLS) $(PNGS) $(JPGS)
3159        rsync -e ssh $^ \
3260            www-data@downloads.qi-hardware.com:werner/wpan/prod/
prod/doc/analysis.html
104104We can therefore consider all results within a range of +/&minus; 1000 ppm as
105105sufficient, and perform more precise measurements by other means. This
106106applies to <B>atben</B> as well as to <B>atusb</B>.
107<P>
108107
109108
110109<!-- ---------------------------------------------------------------------- -->
...... 
120119This configures <B>atben</B> as a promiscuous receiver. The reception
121120of any IEEE 802.15.4 frame or pressing Ctrl-C will terminate the command.
122121<P>
122The clock signal (CLKM) is available on the test pad shown here:
123<P>
124<A href="atben-A.png"><IMG src="atben-A-small.png"></A>
125<P>
123126<TABLE frame="border" cellpadding="2">
124127<TR><TH align="left">Clock<TH align="left">Action
125128<TR><TD>0 Hz<TD>Check voltages; check that the clock is enabled;
...... 
142145of reset, it raises the transceiver's clock output to 8 MHz and then
143146enables USB.
144147<P>
148The clock signal is available at the terminals of several components,
149either as the direct output from the transceiver (CLKM) or after passing
150a low-pass filter (CLK):
151<P>
152<A href="atusb-A.png"><IMG src="atusb-A-small.png"></A>
153<P>
145154<TABLE frame="border" cellpadding="2">
146155<TR><TH align="left">Clock<TH align="left">Action
147156<TR><TD>0 Hz<TD>Check voltages; check for shorts around crystal; check
prod/doc/atben.fig
1#FIG 3.2 Produced by xfig version 3.2.5b
2Landscape
3Center
4Metric
5A4
6100.00
7Single
8-2
91200 2
102 5 0 1 0 -1 100 -1 -1 0.000 0 0 -1 0 0 5
11    0 atben-front.png
12     2475 2475 8790 2475 8790 7161 2475 7161 2475 2475
13# A
142 1 0 3 0 7 50 -1 -1 0.000 0 0 -1 1 0 2
15    1 1 3.00 60.00 120.00
16     1980 4050 2745 4185
17# A
182 1 0 3 4 7 50 -1 -1 0.000 0 0 -1 1 0 2
19    1 1 3.00 60.00 120.00
20     1935 4545 2925 4365
21# A
224 2 0 50 -1 18 24 0.0000 4 300 915 1890 4140 GND\001
23# A
244 2 4 50 -1 18 24 0.0000 4 300 1200 1890 4725 CLKM\001
prod/doc/atusb.fig
1#FIG 3.2 Produced by xfig version 3.2.5b
2Landscape
3Center
4Metric
5A4
6100.00
7Single
8-2
91200 2
102 5 0 1 0 -1 100 -1 20 0.000 0 0 -1 0 0 5
11    0 atusb-front.png
12     6975 2925 9875 2925 9875 9625 6975 9625 6975 2925
13# A
142 1 0 3 0 7 50 -1 -1 0.000 0 0 -1 1 0 2
15    1 1 3.00 60.00 120.00
16     6615 6255 7650 6390
17# A
182 1 0 3 4 7 50 -1 -1 0.000 0 0 -1 1 0 2
19    1 1 3.00 60.00 120.00
20     6570 6795 7605 6570
21# A
222 1 0 3 4 7 50 -1 -1 0.000 0 0 -1 1 0 2
23    1 1 3.00 60.00 120.00
24     6750 7650 8010 6750
25# A
262 1 0 3 4 7 50 -1 -1 0.000 0 0 -1 1 0 2
27    1 1 3.00 60.00 120.00
28     10260 7875 8820 7740
29# A
302 1 0 3 0 7 50 -1 -1 0.000 0 0 -1 1 0 2
31    1 1 3.00 60.00 120.00
32     10305 7380 9540 7605
33# A
342 1 0 3 0 7 50 -1 -1 0.000 0 0 -1 1 0 2
35    1 1 3.00 60.00 120.00
36     6660 8550 7335 8235
37# A
384 2 4 50 -1 18 24 0.0000 4 300 855 6525 6975 CLK\001
39# A
404 2 0 50 -1 18 24 0.0000 4 300 915 6525 6345 GND\001
41# A
424 2 4 50 -1 18 24 0.0000 4 300 1200 6795 8055 CLKM\001
43# A
444 0 0 50 -1 18 24 0.0000 4 300 915 10350 7425 GND\001
45# A
464 0 4 50 -1 18 24 0.0000 4 300 855 10350 8010 CLK\001
47# A
484 2 0 50 -1 18 24 0.0000 4 300 915 6570 8820 GND\001

Archive Download the corresponding diff file



interactive