General ======= Things not done yet ------------------- - document directory hierarchy - make sure all files have a copyright header or are listed in AUTHORS - connect all the bits and pieces of the build system - combine io-parts.h generation - combine "standard" EP0 commands, such as *_ID and *_BUILD - implement return to DFU in application's EP0 protocol - consider removing *_ID and using bcdDevice instead Bugs to fix ----------- - builds fail if .version isn't there yet atrf ==== AT86RF230-based IEEE 802.15.4 transceiver. Two variantes: one to make a USB dongle for use with any Linux host, and one that connects with SPI directly inside a Ben. Things not done yet ------------------- - define values for crystal load capacitors. Measurements with instruments not quite precise enough (+/- 100 ppm) for the task (+/- 40 ppm, preferably < +/- 10 ppm) suggest that we're about 300 ppm off with no capacitors at all and can only correct about 150 ppm with the internal trim capacitors. - examine spectrum around carrier frequency and first harmonic to look for obvious distortions. Vary transmit power. - measure throughput as a function of placement/distance, carrier frequency, and transmit power - atspi-txrx: suppport "extended mode" with IEEE 802.15.4 CSMA-CA for more realistic throughput figures - measure full spectrum (ideally up to 25 GHz, but just 2nd and 3rd harmonic will already tell most of the story) with calibrated antenna for FCC/ETSI compliance assessment. Vary transmit power. - use IEEE 802.15.4 stack from linux-zigbee - verify that the Ben can output an a) 16 MHz clock, and b) with +/- 40 ppm - replace discrete balun and filter with integrated solution, to reduce BOM size, maybe cost, insertion loss, and PCB space - check if we really need three DC blocking caps in the RF path - change layout of transceiver side of the board for placement inside Ben - define EMI filters for placement inside Ben - check USB standard for recommended USB dongle dimensions - change layout for straight USB dongle - generate proper BOM - implement sleep mode Bugs to fix ----------- - two of my systems (tv and u1010) flat out refuse to talk to the board's USB application, but have no problem talking to its DFU boot loader. Very strange. - atrf vs. atspi naming is a bit confusing ccrf ==== Board similar to the atrf, but with the TI/Chipcon CC2520. cntr ==== Simple USB-based counter to measure a clock's long-time accuracy with arbitrarily high precision, by comparing it to an NTP time reference. Things not done yet ------------------- - measure duty cycle - display activity on clock input and duty cycle - consider using a comparator and a DAC to allow for programmable logic levels - evaluate termination resistance - document circuit design