| 1 | config interface loopback |
| 2 | option ifname lo |
| 3 | option proto static |
| 4 | option ipaddr 127.0.0.1 |
| 5 | option netmask 255.0.0.0 |
| 6 | |
| 7 | config interface lan |
| 8 | option ifname eth0 |
| 9 | option type bridge |
| 10 | option proto static |
| 11 | option ipaddr 192.168.1.1 |
| 12 | option netmask 255.255.255.0 |
| 13 | |
| 14 | config interface wan |
| 15 | option ifname eth1 |
| 16 | option proto dhcp |
| 17 | |
| 18 | config switch |
| 19 | option name rtl8366s |
| 20 | option reset 1 |
| 21 | option enable_vlan 1 |
| 22 | # Blinkrate: 0=43ms; 1=84ms; 2=120ms; 3=170ms; 4=340ms; 5=670ms |
| 23 | option blinkrate 2 |
| 24 | |
| 25 | config switch_vlan |
| 26 | option device rtl8366s |
| 27 | option vlan 1 |
| 28 | option ports "0 1 2 3 5" |
| 29 | |
| 30 | config switch_port |
| 31 | # Port 1 controls the GREEN configuration of LEDs for |
| 32 | # the switch and the section does not correspond to a real |
| 33 | # switch port. |
| 34 | # |
| 35 | # 0=LED off; 1=Collision/FDX; 2=Link/activity; 3-1000MB/s |
| 36 | # 4=100 MB/s; 5=10 MB/s; 6=1000 MB/s+activity; 7=100 MB/s+activity |
| 37 | # 8=10 MB/s+activity; 9=10/100 Mb/s+activity; 10: Fiber; |
| 38 | # 11: Fault; 12: Link/activity(tx); 13: Link/activity(rx); |
| 39 | # 14: Link (master); 15: separate register |
| 40 | |
| 41 | option device rtl8366s |
| 42 | option port 1 |
| 43 | option led 9 |
| 44 | |
| 45 | config switch_port |
| 46 | # Port 2 controls the ORANGE configuration of LEDs for |
| 47 | # the switch and the section does not correspond to a real |
| 48 | # switch port. |
| 49 | # |
| 50 | # See the key above for switch port 1 for the meaning of the |
| 51 | # 'led' setting below. |
| 52 | |
| 53 | option device rtl8366s |
| 54 | option port 2 |
| 55 | option led 6 |
| 56 | |
| 57 | |
| 58 | config switch_port |
| 59 | # Port 5 controls the configuration of the WAN LED and the |
| 60 | # section does not correspond to a real switch port. |
| 61 | # |
| 62 | # To toggle the use of green or orange LEDs for the WAN port, |
| 63 | # see the LED setting for wndr3700:green:wan in /etc/config/system. |
| 64 | # |
| 65 | # See the key above for switch port 1 for the meaning of the |
| 66 | # 'led' setting below. |
| 67 | |
| 68 | option device rtl8366s |
| 69 | option port 5 |
| 70 | option led 6 |
| 71 | |
| 72 | |
