| 1 | --- a/drivers/net/phy/Kconfig |
| 2 | +++ b/drivers/net/phy/Kconfig |
| 3 | @@ -215,6 +215,30 @@ config MDIO_BUS_MUX_MMIOREG |
| 4 | |
| 5 | Currently, only 8-bit registers are supported. |
| 6 | |
| 7 | +config RTL8366_SMI |
| 8 | + tristate "Driver for the RTL8366 SMI interface" |
| 9 | + depends on GENERIC_GPIO |
| 10 | + ---help--- |
| 11 | + This module implements the SMI interface protocol which is used |
| 12 | + by some RTL8366 ethernet switch devices via the generic GPIO API. |
| 13 | + |
| 14 | +if RTL8366_SMI |
| 15 | + |
| 16 | +config RTL8366_SMI_DEBUG_FS |
| 17 | + bool "RTL8366 SMI interface debugfs support" |
| 18 | + depends on DEBUG_FS |
| 19 | + default n |
| 20 | + |
| 21 | +config RTL8366S_PHY |
| 22 | + tristate "Driver for the Realtek RTL8366S switch" |
| 23 | + select SWCONFIG |
| 24 | + |
| 25 | +config RTL8366RB_PHY |
| 26 | + tristate "Driver for the Realtek RTL8366RB switch" |
| 27 | + select SWCONFIG |
| 28 | + |
| 29 | +endif # RTL8366_SMI |
| 30 | + |
| 31 | endif # PHYLIB |
| 32 | |
| 33 | config MICREL_KS8995MA |
| 34 | --- a/drivers/net/phy/Makefile |
| 35 | +++ b/drivers/net/phy/Makefile |
| 36 | @@ -23,6 +23,9 @@ obj-$(CONFIG_IP17XX_PHY) += ip17xx.o |
| 37 | obj-$(CONFIG_REALTEK_PHY) += realtek.o |
| 38 | obj-$(CONFIG_AR8216_PHY) += ar8216.o |
| 39 | obj-$(CONFIG_RTL8306_PHY) += rtl8306.o |
| 40 | +obj-$(CONFIG_RTL8366_SMI) += rtl8366_smi.o |
| 41 | +obj-$(CONFIG_RTL8366S_PHY) += rtl8366s.o |
| 42 | +obj-$(CONFIG_RTL8366RB_PHY) += rtl8366rb.o |
| 43 | obj-$(CONFIG_LSI_ET1011C_PHY) += et1011c.o |
| 44 | obj-$(CONFIG_FIXED_PHY) += fixed.o |
| 45 | obj-$(CONFIG_MDIO_BITBANG) += mdio-bitbang.o |
| 46 | |
