Root/package/broadcom-wl/src/driver/proto/bcmevent.h

1/*
2 * Broadcom Event protocol definitions
3 *
4 * Copyright 2007, Broadcom Corporation
5 * All Rights Reserved.
6 *
7 * THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
8 * KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
9 * SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
10 * FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
11 *
12 *
13 * Dependencies: proto/bcmeth.h
14 *
15 *
16 */
17
18/*
19 * Broadcom Ethernet Events protocol defines
20 *
21 */
22
23#ifndef _BCMEVENT_H_
24#define _BCMEVENT_H_
25
26/* enable structure packing */
27#if defined(__GNUC__)
28#define PACKED __attribute__((packed))
29#else
30#pragma pack(1)
31#define PACKED
32#endif /* defined(__GNUC__) */
33
34#define BCM_EVENT_MSG_VERSION 1 /* wl_event_msg_t struct version */
35#define BCM_MSG_IFNAME_MAX 16 /* max length of interface name */
36
37/* flags */
38#define WLC_EVENT_MSG_LINK 0x01 /* link is up */
39#define WLC_EVENT_MSG_FLUSHTXQ 0x02 /* flush tx queue on MIC error */
40#define WLC_EVENT_MSG_GROUP 0x04 /* group MIC error */
41
42/* these fields are stored in network order */
43typedef struct
44{
45    uint16 version;
46    uint16 flags; /* see flags below */
47    uint32 event_type; /* Message (see below) */
48    uint32 status; /* Status code (see below) */
49    uint32 reason; /* Reason code (if applicable) */
50    uint32 auth_type; /* WLC_E_AUTH */
51    uint32 datalen; /* data buf */
52    struct ether_addr addr; /* Station address (if applicable) */
53    char ifname[BCM_MSG_IFNAME_MAX]; /* name of the packet incoming interface */
54} PACKED wl_event_msg_t;
55
56/* used by driver msgs */
57typedef struct bcm_event {
58    struct ether_header eth;
59    bcmeth_hdr_t bcm_hdr;
60    wl_event_msg_t event;
61    /* data portion follows */
62} PACKED bcm_event_t;
63
64#define BCM_MSG_LEN (sizeof(bcm_event_t) - sizeof(bcmeth_hdr_t) - sizeof(struct ether_header))
65
66/* Event messages */
67#define WLC_E_SET_SSID 0 /* indicates status of set SSID */
68#define WLC_E_JOIN 1 /* differentiates join IBSS from found (WLC_E_START) IBSS */
69#define WLC_E_START 2 /* STA founded an IBSS or AP started a BSS */
70#define WLC_E_AUTH 3 /* 802.11 AUTH request */
71#define WLC_E_AUTH_IND 4 /* 802.11 AUTH indication */
72#define WLC_E_DEAUTH 5 /* 802.11 DEAUTH request */
73#define WLC_E_DEAUTH_IND 6 /* 802.11 DEAUTH indication */
74#define WLC_E_ASSOC 7 /* 802.11 ASSOC request */
75#define WLC_E_ASSOC_IND 8 /* 802.11 ASSOC indication */
76#define WLC_E_REASSOC 9 /* 802.11 REASSOC request */
77#define WLC_E_REASSOC_IND 10 /* 802.11 REASSOC indication */
78#define WLC_E_DISASSOC 11 /* 802.11 DISASSOC request */
79#define WLC_E_DISASSOC_IND 12 /* 802.11 DISASSOC indication */
80#define WLC_E_QUIET_START 13 /* 802.11h Quiet period started */
81#define WLC_E_QUIET_END 14 /* 802.11h Quiet period ended */
82#define WLC_E_BEACON_RX 15 /* BEACONS received/lost indication */
83#define WLC_E_LINK 16 /* generic link indication */
84#define WLC_E_MIC_ERROR 17 /* TKIP MIC error occurred */
85#define WLC_E_NDIS_LINK 18 /* NDIS style link indication */
86#define WLC_E_ROAM 19 /* roam attempt occurred: indicate status & reason */
87#define WLC_E_TXFAIL 20 /* change in dot11FailedCount (txfail) */
88#define WLC_E_PMKID_CACHE 21 /* WPA2 pmkid cache indication */
89#define WLC_E_RETROGRADE_TSF 22 /* current AP's TSF value went backward */
90#define WLC_E_PRUNE 23 /* AP was pruned from join list for reason */
91#define WLC_E_AUTOAUTH 24 /* report AutoAuth table entry match for join attempt */
92#define WLC_E_EAPOL_MSG 25 /* Event encapsulating an EAPOL message */
93#define WLC_E_SCAN_COMPLETE 26 /* Scan results are ready or scan was aborted */
94#define WLC_E_ADDTS_IND 27 /* indicate to host addts fail/success */
95#define WLC_E_DELTS_IND 28 /* indicate to host delts fail/success */
96#define WLC_E_BCNSENT_IND 29 /* indicate to host of beacon transmit */
97#define WLC_E_BCNRX_MSG 30 /* Send the received beacon up to the host */
98#define WLC_E_BCNLOST_MSG 31 /* indicate to host loss of beacon */
99#define WLC_E_ROAM_PREP 32 /* before attempting to roam */
100#define WLC_E_PFN_NET_FOUND 33 /* PFN network found event */
101#define WLC_E_PFN_NET_LOST 34 /* PFN network lost event */
102
103#ifdef EXT_STA
104#define WLC_E_RESET_COMPLETE 35
105#define WLC_E_JOIN_START 36
106#define WLC_E_ROAM_START 37
107#define WLC_E_ASSOC_START 38
108#define WLC_E_IBSS_ASSOC 39
109#define WLC_E_RADIO 40
110#define WLC_E_LAST 41 /* highest val + 1 for range checking */
111#else /* EXT_STA */
112#define WLC_E_LAST 35 /* highest val + 1 for range checking */
113#endif /* EXT_STA */
114
115/* Event status codes */
116#define WLC_E_STATUS_SUCCESS 0 /* operation was successful */
117#define WLC_E_STATUS_FAIL 1 /* operation failed */
118#define WLC_E_STATUS_TIMEOUT 2 /* operation timed out */
119#define WLC_E_STATUS_NO_NETWORKS 3 /* failed due to no matching network found */
120#define WLC_E_STATUS_ABORT 4 /* operation was aborted */
121#define WLC_E_STATUS_NO_ACK 5 /* protocol failure: packet not ack'd */
122#define WLC_E_STATUS_UNSOLICITED 6 /* AUTH or ASSOC packet was unsolicited */
123#define WLC_E_STATUS_ATTEMPT 7 /* attempt to assoc to an auto auth configuration */
124#define WLC_E_STATUS_PARTIAL 8 /* scan results are incomplete */
125#define WLC_E_STATUS_NEWSCAN 9 /* scan aborted by another scan */
126#define WLC_E_STATUS_NEWASSOC 10 /* scan aborted due to assoc in progress */
127#define WLC_E_STATUS_11HQUIET 11 /* 802.11h quiet period started */
128#define WLC_E_STATUS_SUPPRESS 12 /* user disabled scanning (WLC_SET_SCANSUPPRESS) */
129#define WLC_E_STATUS_NOCHANS 13 /* no allowable channels to scan */
130#define WLC_E_STATUS_CCXFASTRM 14 /* scan aborted due to CCX fast roam */
131
132/* roam reason codes */
133#define WLC_E_REASON_INITIAL_ASSOC 0 /* initial assoc */
134#define WLC_E_REASON_LOW_RSSI 1 /* roamed due to low RSSI */
135#define WLC_E_REASON_DEAUTH 2 /* roamed due to DEAUTH indication */
136#define WLC_E_REASON_DISASSOC 3 /* roamed due to DISASSOC indication */
137#define WLC_E_REASON_BCNS_LOST 4 /* roamed due to lost beacons */
138#define WLC_E_REASON_FAST_ROAM_FAILED 5 /* roamed due to fast roam failure */
139#define WLC_E_REASON_DIRECTED_ROAM 6 /* roamed due to request by AP */
140#define WLC_E_REASON_TSPEC_REJECTED 7 /* roamed due to TSPEC rejection */
141#define WLC_E_REASON_BETTER_AP 8 /* roamed due to finding better AP */
142
143/* prune reason codes */
144#define WLC_E_PRUNE_ENCR_MISMATCH 1 /* encryption mismatch */
145#define WLC_E_PRUNE_BCAST_BSSID 2 /* AP uses a broadcast BSSID */
146#define WLC_E_PRUNE_MAC_DENY 3 /* STA's MAC addr is in AP's MAC deny list */
147#define WLC_E_PRUNE_MAC_NA 4 /* STA's MAC addr is not in AP's MAC allow list */
148#define WLC_E_PRUNE_REG_PASSV 5 /* AP not allowed due to regulatory restriction */
149#define WLC_E_PRUNE_SPCT_MGMT 6 /* AP does not support STA locale spectrum mgmt */
150#define WLC_E_PRUNE_RADAR 7 /* AP is on a radar channel of STA locale */
151#define WLC_E_RSN_MISMATCH 8 /* STA does not support AP's RSN */
152#define WLC_E_PRUNE_NO_COMMON_RATES 9 /* No rates in common with AP */
153#define WLC_E_PRUNE_BASIC_RATES 10 /* STA does not support all basic rates of BSS */
154#define WLC_E_PRUNE_CIPHER_NA 12 /* BSS's cipher not supported */
155#define WLC_E_PRUNE_KNOWN_STA 13 /* AP is already known to us as a STA */
156#define WLC_E_PRUNE_WDS_PEER 15 /* AP is already known to us as a WDS peer */
157#define WLC_E_PRUNE_QBSS_LOAD 16 /* QBSS LOAD - AAC is too low */
158#define WLC_E_PRUNE_HOME_AP 17 /* prune home AP */
159
160#undef PACKED
161#if !defined(__GNUC__)
162#pragma pack()
163#endif /* PACKED */
164
165#endif /* _BCMEVENT_H_ */
166

Archive Download this file



interactive