| 1 | menu "Configuration" |
| 2 | depends on PACKAGE_uboot-lantiq |
| 3 | |
| 4 | config UBOOT_TARGET |
| 5 | string "target" |
| 6 | default "easy50712_DDR166M" |
| 7 | help |
| 8 | The configuration reflects the settings for a dedicated board hardware. |
| 9 | Select for Danube evaluation board easy50712_DDR166M . |
| 10 | Select for AR9 evaluation board easy50812_DDR166M . |
| 11 | |
| 12 | config UBOOT_RAMBOOT |
| 13 | bool "Enable RAM boot image" |
| 14 | help |
| 15 | Using the UART boot mode of the ROM code this image could be loaded to the RAM. |
| 16 | While executing the image in the RAM the functionality of the uboot image can be |
| 17 | tested first without touching the original flash. |
| 18 | Note: Be carefull, by saving the environment the flash will be modified. |
| 19 | The OWRT flash layout differs from the layout provided by Lantiq / Infineon. |
| 20 | |
| 21 | config UBOOT_RAMBOOT_DDR_CONFIG |
| 22 | string "DDR configuration file" |
| 23 | default "easy50712_DDR166M.conf" |
| 24 | depends on UBOOT_RAMBOOT |
| 25 | help |
| 26 | The DDR configuration file should reflect the DDR memory device configuration . |
| 27 | It will be used to create a RAM boot image |
| 28 | Select for Danube evalution board easy50712_DDR166M.conf . |
| 29 | Select for AR9 evalution board easy50812.conf . |
| 30 | |
| 31 | |
| 32 | config UBOOT_A800 |
| 33 | bool "add ARV452 Switch bringup hack" |
| 34 | help |
| 35 | Say Y, if you have a arv452 board (wav-281, A800, ..) |
| 36 | |
| 37 | endmenu |
| 38 | |
