Root/target/linux/pxa/patches/004-smsc911x_verdex_pro_support.patch

1From 7645a459feb02f7aae4c3a5724b7800495d1b659 Mon Sep 17 00:00:00 2001
2From: Bobby Powers <bobbypowers@gmail.com>
3Date: Wed, 28 Oct 2009 22:41:31 -0400
4Subject: [PATCH] [ARM] smsc911x: Verdex Pro support
5
6Basically Joseph Kortje's patch, cleaned up to apply to Linus's
7tree. Some of the smsc911x.c had been applied already
8
9Signed-off-by: Bobby Powers <bobbypowers@gmail.com>
10---
11 drivers/net/smsc911x.c | 50 +++++++++++++++++++++++++++++++++++++--------
12 drivers/net/smsc911x.h | 2 +-
13 include/linux/smsc911x.h | 11 ++++++++++
14 3 files changed, 53 insertions(+), 10 deletions(-)
15
16--- a/drivers/net/smsc911x.c
17+++ b/drivers/net/smsc911x.c
18@@ -1189,7 +1189,7 @@ static int smsc911x_open(struct net_devi
19         SMSC_WARNING(IFUP,
20             "Timed out waiting for EEPROM busy bit to clear");
21 
22- smsc911x_reg_write(pdata, GPIO_CFG, 0x70070000);
23+ smsc911x_reg_write(pdata, GPIO_CFG, GPIO_CFG_LED1_EN_ | GPIO_CFG_LED2_EN_ | (1 << 20));
24 
25     /* The soft reset above cleared the device's MAC address,
26      * restore it from local copy (set in probe) */
27@@ -1201,8 +1201,8 @@ static int smsc911x_open(struct net_devi
28     smsc911x_reg_write(pdata, INT_EN, 0);
29     smsc911x_reg_write(pdata, INT_STS, 0xFFFFFFFF);
30 
31- /* Set interrupt deassertion to 100uS */
32- intcfg = ((10 << 24) | INT_CFG_IRQ_EN_);
33+ /* Set interrupt deassertion to 22*10uS */
34+ intcfg = ((22 << 24) | INT_CFG_IRQ_EN_);
35 
36     if (pdata->config.irq_polarity) {
37         SMSC_TRACE(IFUP, "irq polarity: active high");
38@@ -1228,7 +1228,7 @@ static int smsc911x_open(struct net_devi
39     temp |= INT_EN_SW_INT_EN_;
40     smsc911x_reg_write(pdata, INT_EN, temp);
41 
42- timeout = 1000;
43+ timeout = 2000;
44     while (timeout--) {
45         if (pdata->software_irq_signal)
46             break;
47@@ -1946,6 +1946,38 @@ static int __devexit smsc911x_drv_remove
48     return 0;
49 }
50 
51+static inline unsigned int is_gumstix_oui(u8 *addr)
52+{
53+ return (addr[0] == 0x00 && addr[1] == 0x15 && addr[2] == 0xC9);
54+}
55+
56+/**
57+ * gen_serial_ether_addr - Generate software assigned Ethernet address
58+ * based on the system_serial number
59+ * @addr: Pointer to a six-byte array containing the Ethernet address
60+ *
61+ * Generate an Ethernet address (MAC) that is not multicast
62+ * and has the local assigned bit set, keyed on the system_serial
63+ */
64+static inline void gen_serial_ether_addr(u8 *addr)
65+{
66+ static u8 ether_serial_digit = 0;
67+ addr [0] = system_serial_high >> 8;
68+ addr [1] = system_serial_high;
69+ addr [2] = system_serial_low >> 24;
70+ addr [3] = system_serial_low >> 16;
71+ addr [4] = system_serial_low >> 8;
72+ addr [5] = (system_serial_low & 0xc0) | /* top bits are from system serial */
73+ (1 << 4) | /* 2 bits identify interface type 1=ether, 2=usb, 3&4 undef */
74+ ((ether_serial_digit++) & 0x0f); /* 15 possible interfaces of each type */
75+
76+ if(!is_gumstix_oui(addr))
77+ {
78+ addr [0] &= 0xfe; /* clear multicast bit */
79+ addr [0] |= 0x02; /* set local assignment bit (IEEE802) */
80+ }
81+}
82+
83 static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
84 {
85     struct net_device *dev;
86@@ -2082,11 +2114,11 @@ static int __devinit smsc911x_drv_probe(
87             SMSC_TRACE(PROBE,
88                 "Mac Address is read from LAN911x EEPROM");
89         } else {
90- /* eeprom values are invalid, generate random MAC */
91- random_ether_addr(dev->dev_addr);
92- smsc911x_set_hw_mac_address(pdata, dev->dev_addr);
93- SMSC_TRACE(PROBE,
94- "MAC Address is set to random_ether_addr");
95+ /* eeprom values are invalid, generate MAC from serial number */
96+ gen_serial_ether_addr(dev->dev_addr);
97+ smsc911x_set_hw_mac_address(pdata, dev->dev_addr);
98+ SMSC_TRACE(PROBE,
99+ "MAC Address is derived from system serial number");
100         }
101     }
102 
103

Archive Download this file



interactive