Root/Documentation/preempt-locking.txt

1          Proper Locking Under a Preemptible Kernel:
2               Keeping Kernel Code Preempt-Safe
3             Robert Love <rml@tech9.net>
4              Last Updated: 28 Aug 2002
5
6
7INTRODUCTION
8
9
10A preemptible kernel creates new locking issues. The issues are the same as
11those under SMP: concurrency and reentrancy. Thankfully, the Linux preemptible
12kernel model leverages existing SMP locking mechanisms. Thus, the kernel
13requires explicit additional locking for very few additional situations.
14
15This document is for all kernel hackers. Developing code in the kernel
16requires protecting these situations.
17 
18
19RULE #1: Per-CPU data structures need explicit protection
20
21
22Two similar problems arise. An example code snippet:
23
24    struct this_needs_locking tux[NR_CPUS];
25    tux[smp_processor_id()] = some_value;
26    /* task is preempted here... */
27    something = tux[smp_processor_id()];
28
29First, since the data is per-CPU, it may not have explicit SMP locking, but
30require it otherwise. Second, when a preempted task is finally rescheduled,
31the previous value of smp_processor_id may not equal the current. You must
32protect these situations by disabling preemption around them.
33
34You can also use put_cpu() and get_cpu(), which will disable preemption.
35
36
37RULE #2: CPU state must be protected.
38
39
40Under preemption, the state of the CPU must be protected. This is arch-
41dependent, but includes CPU structures and state not preserved over a context
42switch. For example, on x86, entering and exiting FPU mode is now a critical
43section that must occur while preemption is disabled. Think what would happen
44if the kernel is executing a floating-point instruction and is then preempted.
45Remember, the kernel does not save FPU state except for user tasks. Therefore,
46upon preemption, the FPU registers will be sold to the lowest bidder. Thus,
47preemption must be disabled around such regions.
48
49Note, some FPU functions are already explicitly preempt safe. For example,
50kernel_fpu_begin and kernel_fpu_end will disable and enable preemption.
51However, math_state_restore must be called with preemption disabled.
52
53
54RULE #3: Lock acquire and release must be performed by same task
55
56
57A lock acquired in one task must be released by the same task. This
58means you can't do oddball things like acquire a lock and go off to
59play while another task releases it. If you want to do something
60like this, acquire and release the task in the same code path and
61have the caller wait on an event by the other task.
62
63
64SOLUTION
65
66
67Data protection under preemption is achieved by disabling preemption for the
68duration of the critical region.
69
70preempt_enable() decrement the preempt counter
71preempt_disable() increment the preempt counter
72preempt_enable_no_resched() decrement, but do not immediately preempt
73preempt_check_resched() if needed, reschedule
74preempt_count() return the preempt counter
75
76The functions are nestable. In other words, you can call preempt_disable
77n-times in a code path, and preemption will not be reenabled until the n-th
78call to preempt_enable. The preempt statements define to nothing if
79preemption is not enabled.
80
81Note that you do not need to explicitly prevent preemption if you are holding
82any locks or interrupts are disabled, since preemption is implicitly disabled
83in those cases.
84
85But keep in mind that 'irqs disabled' is a fundamentally unsafe way of
86disabling preemption - any spin_unlock() decreasing the preemption count
87to 0 might trigger a reschedule. A simple printk() might trigger a reschedule.
88So use this implicit preemption-disabling property only if you know that the
89affected codepath does not do any of this. Best policy is to use this only for
90small, atomic code that you wrote and which calls no complex functions.
91
92Example:
93
94    cpucache_t *cc; /* this is per-CPU */
95    preempt_disable();
96    cc = cc_data(searchp);
97    if (cc && cc->avail) {
98        __free_block(searchp, cc_entry(cc), cc->avail);
99        cc->avail = 0;
100    }
101    preempt_enable();
102    return 0;
103
104Notice how the preemption statements must encompass every reference of the
105critical variables. Another example:
106
107    int buf[NR_CPUS];
108    set_cpu_val(buf);
109    if (buf[smp_processor_id()] == -1) printf(KERN_INFO "wee!\n");
110    spin_lock(&buf_lock);
111    /* ... */
112
113This code is not preempt-safe, but see how easily we can fix it by simply
114moving the spin_lock up two lines.
115
116
117PREVENTING PREEMPTION USING INTERRUPT DISABLING
118
119
120It is possible to prevent a preemption event using local_irq_disable and
121local_irq_save. Note, when doing so, you must be very careful to not cause
122an event that would set need_resched and result in a preemption check. When
123in doubt, rely on locking or explicit preemption disabling.
124
125Note in 2.5 interrupt disabling is now only per-CPU (e.g. local).
126
127An additional concern is proper usage of local_irq_disable and local_irq_save.
128These may be used to protect from preemption, however, on exit, if preemption
129may be enabled, a test to see if preemption is required should be done. If
130these are called from the spin_lock and read/write lock macros, the right thing
131is done. They may also be called within a spin-lock protected region, however,
132if they are ever called outside of this context, a test for preemption should
133be made. Do note that calls from interrupt context or bottom half/ tasklets
134are also protected by preemption locks and so may use the versions which do
135not check preemption.
136

Archive Download this file



interactive