Root/
1 | Kernel driver max6650 |
2 | ===================== |
3 | |
4 | Supported chips: |
5 | * Maxim 6650 / 6651 |
6 | Prefix: 'max6650' |
7 | Addresses scanned: I2C 0x1b, 0x1f, 0x48, 0x4b |
8 | Datasheet: http://pdfserv.maxim-ic.com/en/ds/MAX6650-MAX6651.pdf |
9 | |
10 | Authors: |
11 | Hans J. Koch <hjk@hansjkoch.de> |
12 | John Morris <john.morris@spirentcom.com> |
13 | Claus Gindhart <claus.gindhart@kontron.com> |
14 | |
15 | Description |
16 | ----------- |
17 | |
18 | This driver implements support for the Maxim 6650/6651 |
19 | |
20 | The 2 devices are very similar, but the Maxim 6550 has a reduced feature |
21 | set, e.g. only one fan-input, instead of 4 for the 6651. |
22 | |
23 | The driver is not able to distinguish between the 2 devices. |
24 | |
25 | The driver provides the following sensor accesses in sysfs: |
26 | |
27 | fan1_input ro fan tachometer speed in RPM |
28 | fan2_input ro " |
29 | fan3_input ro " |
30 | fan4_input ro " |
31 | fan1_target rw desired fan speed in RPM (closed loop mode only) |
32 | pwm1_enable rw regulator mode, 0=full on, 1=open loop, 2=closed loop |
33 | pwm1 rw relative speed (0-255), 255=max. speed. |
34 | Used in open loop mode only. |
35 | fan1_div rw sets the speed range the inputs can handle. Legal |
36 | values are 1, 2, 4, and 8. Use lower values for |
37 | faster fans. |
38 | |
39 | Module parameters |
40 | ----------------- |
41 | |
42 | If your board has a BIOS that initializes the MAX6650/6651 correctly, you can |
43 | simply load your module without parameters. It won't touch the configuration |
44 | registers then. If your board BIOS doesn't initialize the chip, or you want |
45 | different settings, you can set the following parameters: |
46 | |
47 | voltage_12V: 5=5V fan, 12=12V fan, 0=don't change |
48 | prescaler: Possible values are 1,2,4,8,16, or 0 for don't change |
49 | clock: The clock frequency in Hz of the chip the driver should assume [254000] |
50 | |
51 | Please have a look at the MAX6650/6651 data sheet and make sure that you fully |
52 | understand the meaning of these parameters before you attempt to change them. |
53 | |
54 |
Branches:
ben-wpan
ben-wpan-stefan
javiroman/ks7010
jz-2.6.34
jz-2.6.34-rc5
jz-2.6.34-rc6
jz-2.6.34-rc7
jz-2.6.35
jz-2.6.36
jz-2.6.37
jz-2.6.38
jz-2.6.39
jz-3.0
jz-3.1
jz-3.11
jz-3.12
jz-3.13
jz-3.15
jz-3.16
jz-3.18-dt
jz-3.2
jz-3.3
jz-3.4
jz-3.5
jz-3.6
jz-3.6-rc2-pwm
jz-3.9
jz-3.9-clk
jz-3.9-rc8
jz47xx
jz47xx-2.6.38
master
Tags:
od-2011-09-04
od-2011-09-18
v2.6.34-rc5
v2.6.34-rc6
v2.6.34-rc7
v3.9