Root/
1 | /* |
2 | * Linux ARCnet driver - COM20020 chipset support - function declarations |
3 | * |
4 | * Written 1997 by David Woodhouse. |
5 | * Written 1994-1999 by Avery Pennarun. |
6 | * Derived from skeleton.c by Donald Becker. |
7 | * |
8 | * Special thanks to Contemporary Controls, Inc. (www.ccontrols.com) |
9 | * for sponsoring the further development of this driver. |
10 | * |
11 | * ********************** |
12 | * |
13 | * The original copyright of skeleton.c was as follows: |
14 | * |
15 | * skeleton.c Written 1993 by Donald Becker. |
16 | * Copyright 1993 United States Government as represented by the |
17 | * Director, National Security Agency. This software may only be used |
18 | * and distributed according to the terms of the GNU General Public License as |
19 | * modified by SRC, incorporated herein by reference. |
20 | * |
21 | * ********************** |
22 | * |
23 | * For more details, see drivers/net/arcnet.c |
24 | * |
25 | * ********************** |
26 | */ |
27 | #ifndef __COM20020_H |
28 | #define __COM20020_H |
29 | |
30 | int com20020_check(struct net_device *dev); |
31 | int com20020_found(struct net_device *dev, int shared); |
32 | extern const struct net_device_ops com20020_netdev_ops; |
33 | |
34 | /* The number of low I/O ports used by the card. */ |
35 | #define ARCNET_TOTAL_SIZE 8 |
36 | |
37 | /* various register addresses */ |
38 | #ifdef CONFIG_SA1100_CT6001 |
39 | #define BUS_ALIGN 2 /* 8 bit device on a 16 bit bus - needs padding */ |
40 | #else |
41 | #define BUS_ALIGN 1 |
42 | #endif |
43 | |
44 | |
45 | #define _INTMASK (ioaddr+BUS_ALIGN*0) /* writable */ |
46 | #define _STATUS (ioaddr+BUS_ALIGN*0) /* readable */ |
47 | #define _COMMAND (ioaddr+BUS_ALIGN*1) /* standard arcnet commands */ |
48 | #define _DIAGSTAT (ioaddr+BUS_ALIGN*1) /* diagnostic status register */ |
49 | #define _ADDR_HI (ioaddr+BUS_ALIGN*2) /* control registers for IO-mapped memory */ |
50 | #define _ADDR_LO (ioaddr+BUS_ALIGN*3) |
51 | #define _MEMDATA (ioaddr+BUS_ALIGN*4) /* data port for IO-mapped memory */ |
52 | #define _SUBADR (ioaddr+BUS_ALIGN*5) /* the extended port _XREG refers to */ |
53 | #define _CONFIG (ioaddr+BUS_ALIGN*6) /* configuration register */ |
54 | #define _XREG (ioaddr+BUS_ALIGN*7) /* extra registers (indexed by _CONFIG |
55 | or _SUBADR) */ |
56 | |
57 | /* in the ADDR_HI register */ |
58 | #define RDDATAflag 0x80 /* next access is a read (not a write) */ |
59 | |
60 | /* in the DIAGSTAT register */ |
61 | #define NEWNXTIDflag 0x02 /* ID to which token is passed has changed */ |
62 | |
63 | /* in the CONFIG register */ |
64 | #define RESETcfg 0x80 /* put card in reset state */ |
65 | #define TXENcfg 0x20 /* enable TX */ |
66 | |
67 | /* in SETUP register */ |
68 | #define PROMISCset 0x10 /* enable RCV_ALL */ |
69 | #define P1MODE 0x80 /* enable P1-MODE for Backplane */ |
70 | #define SLOWARB 0x01 /* enable Slow Arbitration for >=5Mbps */ |
71 | |
72 | /* COM2002x */ |
73 | #define SUB_TENTATIVE 0 /* tentative node ID */ |
74 | #define SUB_NODE 1 /* node ID */ |
75 | #define SUB_SETUP1 2 /* various options */ |
76 | #define SUB_TEST 3 /* test/diag register */ |
77 | |
78 | /* COM20022 only */ |
79 | #define SUB_SETUP2 4 /* sundry options */ |
80 | #define SUB_BUSCTL 5 /* bus control options */ |
81 | #define SUB_DMACOUNT 6 /* DMA count options */ |
82 | |
83 | #define SET_SUBADR(x) do { \ |
84 | if ((x) < 4) \ |
85 | { \ |
86 | lp->config = (lp->config & ~0x03) | (x); \ |
87 | SETCONF; \ |
88 | } \ |
89 | else \ |
90 | { \ |
91 | outb(x, _SUBADR); \ |
92 | } \ |
93 | } while (0) |
94 | |
95 | #undef ARCRESET |
96 | #undef ASTATUS |
97 | #undef ACOMMAND |
98 | #undef AINTMASK |
99 | |
100 | #define ARCRESET { outb(lp->config | 0x80, _CONFIG); \ |
101 | udelay(5); \ |
102 | outb(lp->config , _CONFIG); \ |
103 | } |
104 | #define ARCRESET0 { outb(0x18 | 0x80, _CONFIG); \ |
105 | udelay(5); \ |
106 | outb(0x18 , _CONFIG); \ |
107 | } |
108 | |
109 | #define ASTATUS() inb(_STATUS) |
110 | #define ADIAGSTATUS() inb(_DIAGSTAT) |
111 | #define ACOMMAND(cmd) outb((cmd),_COMMAND) |
112 | #define AINTMASK(msk) outb((msk),_INTMASK) |
113 | |
114 | #define SETCONF outb(lp->config, _CONFIG) |
115 | |
116 | #endif /* __COM20020_H */ |
117 |
Branches:
ben-wpan
ben-wpan-stefan
javiroman/ks7010
jz-2.6.34
jz-2.6.34-rc5
jz-2.6.34-rc6
jz-2.6.34-rc7
jz-2.6.35
jz-2.6.36
jz-2.6.37
jz-2.6.38
jz-2.6.39
jz-3.0
jz-3.1
jz-3.11
jz-3.12
jz-3.13
jz-3.15
jz-3.16
jz-3.18-dt
jz-3.2
jz-3.3
jz-3.4
jz-3.5
jz-3.6
jz-3.6-rc2-pwm
jz-3.9
jz-3.9-clk
jz-3.9-rc8
jz47xx
jz47xx-2.6.38
master
Tags:
od-2011-09-04
od-2011-09-18
v2.6.34-rc5
v2.6.34-rc6
v2.6.34-rc7
v3.9